Join us now.
Boost your workouts with WiemsPlus.
Get better results in less time.
Join us now.
Boost your workouts with WiemsPlus.
Get better results in less time.
Slim Plus Tutorials
How to properly moisten the electrodes to ensure perfect functioning of the Slim Plus personal suit.
How to put on and take off the suit correctly after use, and wash it carefully to ensure proper maintenance.
WiemsPlus App Tutorials
We explain how to create an account from scratch.
How to pre-link your heart rate monitor before starting a workout.
How to calibrate the intensity of EMS before training. Customize it quickly!
Settings and others.
Start a workout: workout screen.
Training charts.
Device V1 Tutorials
Description: What is EMS device?
How to pair the device with the app.
How to charge the device correctly.
Pay attention!
Wet the electrodes
It is important that both the electrodes and the patch containing them are moistened with plenty of water to guarantee correct conductivity.
Put on the suit
When putting on the Slim Plus personal suit, we must ensure that the electrodes are perfectly placed in their corresponding muscle groups.
Wash it correctly
To ensure proper maintenance and hygiene of the suit, we recommend that you wash it by hand with cold water and pH neutral soap every 3 uses, or 2 weeks.
FaQs
Cables
Check that all cables, including the trunk, are connected correctly. Also make sure if in the previous session it worked correctly or had any problems.
Check the condition of the cable in case it has any abnormalities in its thickness or at its ends. Check if the cable stretches in the snap or head area, if it stretches it means it is broken.
Rule out that it is a device problem.
Check that the main connector moves or becomes loose when connected to the device. If it is under warranty, it is replaced with a new one.
Suits
Check that all cables, including the trunk, are connected correctly. Also make sure if in the previous session it worked correctly or had any problems.
If the purchase was made less than 6 months ago, it will be sent for repair.
If the suit has a defect and the suit was purchased less than 6 months ago, it will be sent for repair.
Table of measurements and maintenance tips
1. The lycra and electrodes have fabric that can suffer wear due to the accumulation of mineral salts, We recommend that the suit be immersed in cold water to extract the mineral salts that accumulate in the fabric after training (It is recommended to eliminate the accumulation of salts once every two weeks).
2. If the suit has whitish areas on the outside or a bad smell, we are doing poor maintenance of the suit.
3. The suit is for personal use, it is designed to be worn 2 or 3 times a week for EMS training. The warranty for this suit only covers manufacturing defects and all types of wear, damage or misuse are outside the warranty.
4. It is recommended to clean delicate areas when you finish training to avoid the spread of bad odors and bacteria in the fabric. Wash with neutral soap or an antibacterial product sprayed or sprayed in the armpit and pants areas, allowing them to dry in a ventilated area (at least every 3 or 4 workouts).
5. We recommend adjusting the interior cables of the suit every 4 sessions to avoid strain on the wiring.
6. It is important before training to check the cable tensions at the waist.
7. If any channel does not broadcast correctly, the client must review the following protocol:
- To make sure, if it is connected and it still does not emit well, we wait for a break to check the connection with the suit device.
- The electrode should be moistened if the cable is connected to improve conductivity. Whenever this process is carried out, the training must be paused.
- If this process does not solve the problem, we check that the cable is in good condition.
⚠ Suits that are sent damp or in inadequate hygienic conditions will not be accepted for warranty management.
Do you need customer service?
- soporte@wiemspro.com
- Jacinto Verdaguer Street, 11, 29002 Málaga, España